Labas, Svečias. Prašome prisijungti arba užsiregistruoti. Did you miss your activation email?




« ankstesnis sekantis »
Puslapiai: 1 2 [3] 4 5 ... 7   Žemyn

Autorius Tema: VAG-COM, VCDS label failai  (Skaityta 66077 kartus)

Neprisijungęs dariniz

  • Įrašai: 163
    • Žiūrėti profilį
Re: VAG-COM, VCDS label failai
« Atsakymas #50: 2009 Vasario 25, 20:34:12 »
Ramzis3
kaip seilė? dar nevarva?  :D

;
; VAG-COM Labeldatei
;
; Audi A4 (8D)
;
; Komponente: Motor (#01) - AFN/AVG
;
; T/N: 038 906 018 ??
;
; beinhaltet Messwertgruppen und Codierung
;
; This file is part of a redirection package,
; make sure you have all of the following files.
;
; 03-01.LBL
; 038-906-018-AFN.LBL (1.9l TDI @ 110 HP - AFN/AVG)
;
; 028-906-021-AFN.LBL erstellt von Sebastian Stange (sebastian@ross-tech.com)
; angepasst fьr Passat 3B (AFN) am 15.05.2005 von Bernhard Hцgl (bernhard@hoegl-net.de)
; geteilt am 23.05.2005 von Sebastian Stange (sebastian@ross-tech.com)
;
; letzte Дnderung: 23.05.2005
;
; benцtigt mindestens VAG-COM 405.0 oder hцher
;
;
;---------------------------------------------------
;
; Messwertgruppen Informationen
;
;---------------------------------------------------
;
0,0,General Engine Status (idling / coolant temperature not below +85 °C)
0,1,Engine speed,idle: 37...42 OK \nfull throttle: 160...190
0,2,Commencement of injection,idle: 20...60 OK \nfull throttle: 180...245  (dependent on engine speed) OK
0,3,Accelerator pedal position,idle: 0 (not pressed) \nfull throttle: 255 (floored)
0,4,Injection quantity,idle: 10...30 OK \nfull throttle: 190...210 (full throttle quantity) OK
0,5,Intake manifold pressure (Boost pressure),idle: ignore \nfull throttle: 180...200 OK
0,6,Atmospheric pressure,no specification
0,7,Coolant temperature,80...51 OK
0,8,Intake air temperature,no specification
0,9,Fuel temperature,90 no specification
0,10,Intake air quantity,idle: 70...110 OK \nfull throttle: more than 240 OK
;
001,0,Values for injection pump (idling coolant temperature +80 °C)
001,1,Engine speed,780...900 rpm
001,2,Inj. quantity,2.0...9.0 mg/H,(see label file)
;-------------------------------------------------------------------------------------------------------
; 001.2 Injection quantity
;=======================================================================================================
; DISPLAY     |     POSSIBLE FAULT CAUSE     |     FAULT ELIMINATION
; ------------|------------------------------|----------------------------------------------------------
;  2.0...9.0  |-O.K.                         |*O.K
;  mg/stroke  |                              |
;-------------|------------------------------|----------------------------------------------------------
;   > 2.0     |-Injection pump too rich      |*Replace injection pump
;  mg/stroke  |                              |
;-------------|------------------------------|----------------------------------------------------------
; 9.0 g/s >   |-Engine loaded                |*Switch off consumption units
;  mg/stroke  |-Engine too cold              |*Allow engine to warm up (see display zone 4)
;             |-Injection pump too lean      |*Replace injection pump
;=======================================================================================================
;
001,3,Voltage G149,1.25...1.75 V,(see label file)
;-------------------------------------------------------------------------------------------------------
; 001.3 Voltage from modulating piston movement sender -G149
;=======================================================================================================
; DISPLAY     |     POSSIBLE FAULT CAUSE     |     FAULT ELIMINATION
; ------------|------------------------------|----------------------------------------------------------
;1.25...1.75 V|-O.K.                         |*O.K
;-------------|------------------------------|----------------------------------------------------------
;   > 1.25 V  |-Injection pump too rich      |*Replace injection pump
;-------------|------------------------------|----------------------------------------------------------
;   1.75 V >  |-Engine loaded                |*Switch off consumption units
;             |-Engine too cold              |*Allow engine to warm up (see display zone 4)
;             |-Injection pump too lean      |*Replace injection pump
;=======================================================================================================
;
001,4,Coolant temp.,85...100 °C
Prisijungęs
Puslapiai: 1 2 [3] 4 5 ... 7   Viršun
« ankstesnis sekantis »
 

Related Topics

  Antraštė / Pradėjo Atsakymai Paskutinis įrašas
16 Atsakymai
4978 Peržiūrėta 		Paskutinis įrašas 2010 Spalio 14, 20:07:50
sukūrė Driftu
0 Atsakymai
1136 Peržiūrėta 		Paskutinis įrašas 2013 Kovo 18, 21:01:10
sukūrė Bajoras
29 Atsakymai
8925 Peržiūrėta 		Paskutinis įrašas 2013 Spalio 12, 15:25:54
sukūrė DIMsonAs