rbrts
Na tikiuosiu angliskai supranti
Pradekim nuo to kad tau reikia turetu du spec irankius(arba kazka panasaus prisitaikyt)
ir
Required filling quantities/torques
Filling quantities and specifications
Gearbox Multitronic 01J, New filling 7,50 litres; Multitronic 01J, Amount to change 5,00 litres
Oil specification Multitronic 01J G 052 180 A2
Tightening torques
Self-locking screws and nuts must always be replaced. Oil drain plug(s) (1) (see Figure1) with Multitronic 24 Nm
Oil control screw(s) (2) (see Figure1) with Multitronic 30 Nm
Replace automatic gearbox oil.
Drain:
Switch off ignition.
Gearbox may not be in emergency operation.
Gear oil temperature ≤ 30°C
Clean the immediate area around the components.
Unscrew oil drain plug(s). (1)
Socket wrench bit AUT (3357)
Collect drained oil.
Observe disposal regulations!
Tighten oil drain plug(s). (1)
(see Figure1)
Top up:
Unscrew oil control screw(s). (2)
Screw in hose of oil filler neck.
(see Figure1)
Turn changeover cock. (2) (arrow )
(see Figure2)
Top up gearbox oil. (4,5-5 l)
Set selector lever to position "P".
Start engine and run in idle.
Vehicles from model year 2005
Set selector lever to position "P".
Start engine and shortly increase engine speed to 2500 min - 1
Test conditions:
Gearbox may not be in emergency operation. ATF temperature ≤ 30°C
Position the vehicle on a level, horizontal and clean surface.
Switch off air conditioning system. Switch off heating.
Read out ATF temperature using a suitable diagnostic unit. Test value : 35° - 45°C
Check ATF filling level.
Set selector lever to position "P".
Start engine and shortly increase engine speed to 2500 min - 1.
Actuate brake pedal
Set selector lever alternately to positions "R" and "D" for approx. 2 seconds. ( at idle speed )
Repeat process three times.
Place selector lever, while stationary, at each position for 2 to 3 seconds in each case. ( at idle speed )
Screw out oil check screw at 35 °C ATF temperature.
Approx. 50 ml ATF will always escape on slackening the oil check screw.
Turn changeover cock. (2) (arrow )
(see Figure3)
The ATF must continuously run out in the case of 35°C.
Wait until little ATF is still running out.
Tighten the oil control screw(s).
Screw in oil check screw at 45°C latest.
Refill ATF when no or very little ATF runs out till 40°C